Sunday, December 22, 2019

Gas Hot Water Heater Repairs

https://www.facebook.com/TX-Sugar-Land-Water-Heater-383014032279865/

 
1- Be sure the gas to the water heater is turned on. Turn the gas control knob to PILOT to prevent the burner from igniting when you are looking inside. Remove the metal cover at the bottom of the water heater and look to see if the burner and/or pilot light—the small flame at the end of the pilot gas supply tube—are lit.
 
2 -If the water heater’s pilot light has gone out, follow the instructions on the tank to relight it.It’s also possible that the gas inlet valve has been closed partially or all the way. If so, turn the handle parallel to the line and relight the pilot. If the pilot won’t light, the thermocouple may be defective—either call your gas utility company (a free service in many areas) or a water heater repair person. (Newer water heaters may have a glow plug or spark ignitor instead of a pilot—follow repair instructions in your owner’s manual.)
 
3 -If the burner is not on, replace the cover and make sure the thermostat is set to about 120 degrees F. If it isn’t, adjust it, turn on a hot water faucet, and then wait a few minutes to see if the water heater burner ignites. If it doesn’t ignite, leave the hot water running and try lowering and then raising the temperature setting on the dial until the burner ignites.
 
4- If the burner ignites, replace the cover and turn the thermostat back to an appropriate setting. If the burner doesn’t ignite, have the water heater checked out by an appliance repair person. It could be that the heater’s thermostat is defective. Replacement is best left to an appliance repair person or a water heater specialist.
 
5- Smell for gas. If you smell a garlic-like scent, turn the gas valve control to OFF (you may have to push down to turn it). Wait until the gas smell has dissipated before relighting the pilot light.
 
Tel : (832) 510-6972
 
 

No comments:

Post a Comment